- 1 Do you need boat trailer guides?
- 2 How tall should trailer guides be?
- 3 How far do you back a boat trailer into the water?
- 4 What are boat trailer guides for?
- 5 What size trailer do I need for two side by sides?
- 6 What is a transom saver?
- 7 How are boat guides measured?
- 8 How do you load a boat trailer with a roller?
- 9 What is the first thing you should do after retrieving a boat onto a trailer?
Do you need boat trailer guides?
And no matter what kind of hull supports your boat trailer has, trailer guides can help prevent damage to the bottom of your boat. It’s very easy to run the bottom of your boat into a roller bracket, the trailer frame, or trailer fenders when trying to load your boat. The decision to put guides on my trailer was easy.
How tall should trailer guides be?
Post style guide-ons normally range from 36 inches to 60 inches in height. The higher the guide-on, the easier it is to see. Bunk style guide-ons are normally much lower and are usually at a height of 18 inches to 24 inches.
How far do you back a boat trailer into the water?
It should be just about as deep as it was when taking the boat off, and in most cases, about two-thirds of the trailer will be submerged while one-third remains out of the water. Don’t submerge the trailer too deep, or the bow of the boat may float over the bunks and go off to the side.
What are boat trailer guides for?
Boat trailer guides, or guide-ons, attach to your trailer and help you easily, safely, and accurately load or unload your boat. They’re simple tools, but they can help you avoid accidents and damage to your boat.
What size trailer do I need for two side by sides?
If you want to haul two UTVs, you’ll need to upgrade to at least a 20-foot trailer with a double axle setup for the extra weight. You’ll want a width of at least 60 inches, but shouldn’t need anything wider than about 76 inches unless you’re rocking a killer custom suspension.
What is a transom saver?
The transom saver is a device that protects your boat’s transom from stress or eventual damage from forces exerted on it by the weight of the outboard while you are trailering it. It is a bar that extends from the outboard to your trailer.
How are boat guides measured?
How to Measure Your Boat for Transport
- Overall Length is measured from the tip of the bow to the center of the stern.
- Overall Height is measured from the bottom of the keel to the highest non-removable part of the boat.
- Beam is measured from the widest point of the boat, including the rub-rail.
How do you load a boat trailer with a roller?
How to Load a Boat on a Roller Trailer
- Back the trailer down just until the back rollers are under water.
- Then drive the boat onto the trailer.
- If it won’t go all the way to the winch post, clip on the winch strap and winch the boat the rest of the way.
What is the first thing you should do after retrieving a boat onto a trailer?
Your trailer and tow vehicle are still on the ramp and the stern is still in water.
- Drive up the ramp to clear the area for the next user.
- Park your rig.
- Remove your stern plug.
- Secure your boat for travel.
- If you have an outboard or outdrive, mechanically lock it in the up position.
- Reconnect trailer lights and test.